The preparation before production of the wooden door transfer machine, the specific operating procedures are as follows:
1. Whether the power supply, voltage, compressed air pressure, and vacuum pump of the wooden door transfer machine are operating normally. Whether the furnace temperature reaches the set more than 200 degrees, the wood grain transfer can only be carried out after the equipment functions and all aspects are running normally.
2. The surface of the workpiece that needs wood grain transfer must be sprayed with plastic powder. The purpose is to coat the surface of the workpiece so that the ink of the transfer paper can pass through the underside of the plastic powder through high temperature to complete the wood grain transfer process.
3. The surface of the wooden door transfer machine is kept clean and free of dust and garbage to ensure the surface texture and gloss of the transfer workpiece.
4. The bagging type wooden door transfer machine, according to the size of the profile area, cut the paper bag. Put the profile into a paper bag, and the bag should be 1/3 larger than the outer size of the workpiece. In order to ensure that each surface of the profile can be completely absorbed in place. Ensure that there is no leakage.
5. Cover-type wooden door transfer machine, if the side of the workpiece does not need to be transferred, it can be directly cut the matching transfer paper according to the size of the workpiece plane. If the side of the workpiece needs to be transferred in place, cut the transfer paper according to the width of the side of the workpiece and the width of the plane, and just cover the entire transfer paper directly.
6. Place the workpiece to be transferred on the workbench. If the pattern of the workpiece does not exceed 1.5 cm, the transfer paper is directly laid flat, and the four corners of the workpiece are placed with a smaller silica gel plate, which can be vacuum absorbed. If the pattern of the workpiece exceeds 1.5 cm, the transfer paper can be sprayed with water and knead it or use a utility knife to make a cut on the pattern. The purpose is to make the transfer paper and the pattern of the workpiece can be completely absorbed in place. The four corners of the work piece are placed on a smaller silica gel plate, and it can be vacuumed.
